Sullivan Palatek SPS145 Heatless Regenerative Air Dryer

Compressed air enters the dryer and is directed to a tower by the inlet valves. It then proceeds up through the tower, gives up its moisture and then exits through the outlet check valve. A portion of the dry air, called purge is metered and expanded to atmospheric pressure through an orifice assembly. The purge air enters the regeneration tower through the purge check valve, the purge air then utilizes a result of the adsorption process called, heat of adsorption to facilitate regeneration of the desiccant. The moisture is picked up by the purge air and exits to the atmosphere through the purge exhaust valve and muffler. The drying and regenerating cycles coincide for 5 min. Just before the end of the 5 min cycle the purge valve closes and the regeneration tower repressurizes before the inlet valves invert and the process starts again.
SP Heatless Regenerative Air Dryer, Series: SPS, 1 in Inlet Connection, NPT Inlet Connection, 1 in Outlet Connection, NPT Outlet Connection, 100 deg F Inlet Air Temperature, Air Flow Rate: 145 scfm, 120 psig Air Pressure

• NEMA 4 electrical
• OSHA approved mufflers
• Illuminated On/Off power switch
• ASME/CRN vessels 75 scfm and up
• ASME relief valves
• Control air filter
• Adjustable purge flow with indicator
• Tower pressure gauges
• Independent desiccant fill and drain ports

• Catalog https://assets.unilogcorp.com/267/ITEM/DOC/SP_SPBS115_Catalog.pdf
• Warranty Information https://assets.unilogcorp.com/267/ITEM/DOC/SP_SPBS115_Warranty.pdf