Thermal Transfer 57567 PWM Variable Fan Controller, 100 to 200 deg F

This combined sensor and controller is designed to mount directly to the heat exchanger. It provides accurate temperature control by cycling the electric cooling fan to maintain desired oil temperature. A single housing reduces wiring and mechanical installation. The MAGHEX magnetic wand is used to set up and program the sensor. Not needed for operation. LEDs indicate the oil temperature setting.
TTP PWM Variable Fan Controller, 100 to 200 deg F, 12/24 VDC, Anodized Aluminum

• Easy installation and integration into MA Series (any SAE#8 port or cavity)
• Creates a simple drive circuit with just a few wires and minimal programming
• Low cost alternative to complex control systems
• Utilize built-in temperature sensor to activate the fan based upon current set point
• Capable of providing on-board programming and status without the additional component requirements
• 12 or 24 VDC operation up to 30 A
• Temperature sensor and operation controller in single aluminum housing
• Mounts directly to the cooler
• Connector to fan is included and pre-wired
• Solid state design, no moving parts, fully sealed microprocessor/FET design
• Manual override feature built-in
• Shuts-off 7 deg below set point
• Improved circuitry to accommodate higher amperage applications
• Housing is used as a heat sink for internal components
• Automatic low voltage shut down

• Catalog https://assets.unilogcorp.com/267/ITEM/DOC/TTP_57565_Catalog.pdf